Implementing rover speed control in Paparazzi UAV
Ver/ abrir
Use este enlace para citar
http://hdl.handle.net/2183/33623
A non ser que se indique outra cousa, a licenza do ítem descríbese como Attribution-NonCommercial-ShareAlike 4.0 International (CC BY-NC-SA 4.0) https://creativecommons.org/licenses/by-nc-sa/4.0/
Coleccións
Metadatos
Mostrar o rexistro completo do ítemTítulo
Implementing rover speed control in Paparazzi UAVData
2023Cita bibliográfica
González-Calvin, A., Jiménez, J.F., García-Pérez, L. 2023. Implementing rover speed control in Paparazzi UAV. XLIV Jornadas de Automática, 306-310. https://doi.org/10.17979/spudc.9788497498609.306
Resumo
[Abstract] This paper presents the design, implementation and testing of a speed controller for an autonomous rover with an unicycle drive. The aim is to get the rover to follow the speed setpoint as accurately as possible based on low cost GPS measurements. The use of IMU and GPS measurements was investigated and a moving average filter was designed to use the GPS signal as feedback for the speed controller. This filter and speed control were implemented on a flight controller board on a small autonomous rover using the the Paparazzi UAV development framework. Outdoor tests were performed.
Palabras chave
Filtering and smoothing
Moving average filter
Speed control
Autonomous rover
Control of systems in vehicles
GPS
Moving average filter
Speed control
Autonomous rover
Control of systems in vehicles
GPS
Versión do editor
Dereitos
Attribution-NonCommercial-ShareAlike 4.0 International (CC BY-NC-SA 4.0) https://creativecommons.org/licenses/by-nc-sa/4.0/
ISBN
978‐84‐9749‐860‐9