Implementing rover speed control in Paparazzi UAV
Ver/Abrir
Use este enlace para citar
http://hdl.handle.net/2183/33623
Excepto si se señala otra cosa, la licencia del ítem se describe como Attribution-NonCommercial-ShareAlike 4.0 International (CC BY-NC-SA 4.0) https://creativecommons.org/licenses/by-nc-sa/4.0/
Colecciones
Metadatos
Mostrar el registro completo del ítemTítulo
Implementing rover speed control in Paparazzi UAVFecha
2023Cita bibliográfica
González-Calvin, A., Jiménez, J.F., García-Pérez, L. 2023. Implementing rover speed control in Paparazzi UAV. XLIV Jornadas de Automática, 306-310. https://doi.org/10.17979/spudc.9788497498609.306
Resumen
[Abstract] This paper presents the design, implementation and testing of a speed controller for an autonomous rover with an unicycle drive. The aim is to get the rover to follow the speed setpoint as accurately as possible based on low cost GPS measurements. The use of IMU and GPS measurements was investigated and a moving average filter was designed to use the GPS signal as feedback for the speed controller. This filter and speed control were implemented on a flight controller board on a small autonomous rover using the the Paparazzi UAV development framework. Outdoor tests were performed.
Palabras clave
Filtering and smoothing
Moving average filter
Speed control
Autonomous rover
Control of systems in vehicles
GPS
Moving average filter
Speed control
Autonomous rover
Control of systems in vehicles
GPS
Versión del editor
Derechos
Attribution-NonCommercial-ShareAlike 4.0 International (CC BY-NC-SA 4.0) https://creativecommons.org/licenses/by-nc-sa/4.0/
ISBN
978‐84‐9749‐860‐9