Laser surface tempering of hardened chromium-molybdenum alloyed steel
Ver/ abrir
Use este enlace para citar
http://hdl.handle.net/2183/37347
A non ser que se indique outra cousa, a licenza do ítem descríbese como Attribution-NonCommercial-NoDerivatives 4.0 International
https://creativecommons.org/licenses/by-nc-nd/4.0/
Coleccións
Metadatos
Mostrar o rexistro completo do ítemTítulo
Laser surface tempering of hardened chromium-molybdenum alloyed steelData
2018-09-03Cita bibliográfica
SORIANO, Carlos, ALBERDI, Goretti, LAMBARRI, Jon, ARANZABE, Ana and YÁÑEZ, Armando, 2018. Laser surface tempering of hardened chromium-molybdenum alloyed steel. Procedia CIRP. Online. 2018. Vol. 74, p. 353–356. DOI 10.1016/j.procir.2018.08.140. [Accessed 25 June 2024].
Resumo
[Abstract]: The effect of a laser tempering process, subsequent to a laser hardening treatment, on the microstructure, microhardness, structural composition
of phases and residual stresses of a 42CrMo4 steel has been studied. The tempering process has been carried out using a 10 kW diode laser and
a galvanometer scanner head. Results show that the subsequent tempering process, after the laser hardening treatment, can be a complementary
and effective method to adjust, through the selection of the appropriate process parameters, the desired degree of hardness and tensional state of
the processed area, attending to the specific requirements demanded in a component.
Palabras chave
Laser tempering
Martensite
Tempered martensite
Retained austenite
42CMo4
Martensite
Tempered martensite
Retained austenite
42CMo4
Versión do editor
Dereitos
Attribution-NonCommercial-NoDerivatives 4.0 International
https://creativecommons.org/licenses/by-nc-nd/4.0/
ISSN
2212-8271