A validation of the boundary element method for grounding grid design and computation
Ver/ abrir
Use este enlace para citar
http://hdl.handle.net/2183/342Coleccións
Metadatos
Mostrar o rexistro completo do ítemTítulo
A validation of the boundary element method for grounding grid design and computationData
1992Cita bibliográfica
Métodos numéricos en ingeniería y ciencias aplicadas : actas del Congreso
Internacional sobre Métodos Numéricos en Ingeniería y Ciencias Aplicadas
celebrado en la Universidad de Concepción, Chile, del 16 al 20 de
noviembre de 1992 = Numerical methods in engineering and applied sciences
: proceedings of the International Congress on Numerical Methods in
Engineering and Applied Sciences, held at University of Concepción, Chile,
16-20 November 1992, H. Alder ... et al.(eds.), p. 1187-1196
Resumo
[Abstract] Several widespread intuitive techniques developed during the last two decades for substation grounding analysis, such as the Average Potential Method
(APM), have been recently identified as particular cases of a more general Boundary Element formulation [1]. In this approach, problems encountered with the
application of these methods [3] can be explained from a mathematically rigorous point of view, and innovative advanced and more eficient techniques can be
derived [2].
Numerical results obtained with low and medium levels of discretization
(equivalent resistance and leakage current density) seem to be reasonable. However, these solutions still have not been validated. Unrealistic results are obtained when domain discretization is increased, since no one procedure is yet
available to eliminate the above mentioned problems. Hence, numerical convergence analyses are precluded. The obtention of highly accurate numerical
results by means of standard techniques (FEM, Finite Differences) implies unapproachable computing requirements in practical cases. On the other side,
neither practical error estimates have been derived, nor analytical solutions are
known for practical cases, nor suficiently accurate experimental measurements
have been reported up to this point.
In this paper, we present a validation of the results obtained by the Boundary Element proposed formulation, including the classical methods. A highly
accurate solution to a specially designed test problem is obtained by means of a
2D FEM model, using up to 80; 000 degrees of freedom. Results are compared
with those carried out by Boundary Elements.
ISBN
84-87867-16-2