Mostrar o rexistro simple do ítem

dc.contributor.authorBueno-López, José Luis
dc.contributor.authorCardenal, Jesús
dc.contributor.authorDeibe Díaz, Álvaro
dc.contributor.authorGarcía de Jalón, Javier
dc.date.accessioned2018-06-06T17:04:24Z
dc.date.available2018-06-06T17:04:24Z
dc.date.issued2018
dc.identifier.issn1424-8220
dc.identifier.urihttp://hdl.handle.net/2183/20789
dc.description.abstract[Abstract:] A new methodology for the estimation of tyre-contact forces is presented. The new procedure is an evolution of a previous method based on harmonic elimination techniques developed with the aim of producing low cost dynamometric wheels. While the original method required stress measurement in many rim radial lines and the fulfillment of some rigid conditions of symmetry, the new methodology described in this article significantly reduces the number of required measurement points and greatly relaxes symmetry constraints. This can be done without compromising the estimation error level. The reduction of the number of measuring radial lines increases the ripple of demodulated signals due to non-eliminated higher order harmonics. Therefore, it is necessary to adapt the calibration procedure to this new scenario. A new calibration procedure that takes into account angular position of the wheel is completely described. This new methodology is tested on a standard commercial five-spoke car wheel. Obtained results are qualitatively compared to those derived from the application of former methodology leading to the conclusion that the new method is both simpler and more robust due to the reduction in the number of measuring points, while contact forces’ estimation error remains at an acceptable level.
dc.description.sponsorshipMinisterio de Ciencia e Innovación; TRA2012-38826-C02-01
dc.description.sponsorshipMadrid (Comunidad Autónoma); S2013-MIT2713
dc.language.isoenges_ES
dc.publisherMDPIes_ES
dc.relation.urihttps://doi.org/10.3390/s18020541es_ES
dc.rights.urihttp://creativecommons.org/licenses/by/3.0/es/*
dc.subjectMeasuring wheeles_ES
dc.subjectDynamometric wheeles_ES
dc.subjectWheel transduceres_ES
dc.subjectForces measurementes_ES
dc.titlePotential and Limitations of an Improved Method to Produce Dynamometric Wheelses_ES
dc.typeinfo:eu-repo/semantics/articlees_ES
dc.rights.accessinfo:eu-repo/semantics/openAccesses_ES
UDC.journalTitleSensorses_ES
UDC.volume18es_ES
UDC.issue2es_ES
UDC.startPage1es_ES
UDC.endPage19es_ES
dc.identifier.doi10.3390/s18020541


Ficheiros no ítem

Thumbnail
Thumbnail

Este ítem aparece na(s) seguinte(s) colección(s)

Mostrar o rexistro simple do ítem