Buscar
Mostrando ítems 11-20 de 38
Effects of the asphalt penetration grade and the mineralogical composition on the asphalt-aggregate bond
(Taylor & Francis, 2014)
[Abstract:] This investigation analyzes the loss of bonding between the asphalt binder and the aggregate particles produced by water in hot-mix asphalt pavements. Three asphalt penetration grades were used: B35/50, B50/70, ...
Recycled construction and demolition waste in Cold Asphalt Mixtures : evolutionary properties
(Elsevier, 2016)
[Abstract:] The use of Cold Asphalt Mixtures (CAM) usually results in financial and environmental saving, while decreasing pollution and occupational hazards. However, they require a length of curing time to reach their ...
Feasibility of Using Recycled Concrete Aggregates for Half-Warm mix Asphalt
(Springer, 2018)
[Abstract:] The present study describes a laboratory investigation on the feasibility of reusing construction and
demolition waste as recycled concrete aggregate (RCA) to manufacture half-warm mix asphalt
(HWMA) instead ...
Treatments applied to recycled concrete aggregates when used in hot-mix asphalt
(TRB, 2015)
[Abstract:] The road construction industry is one of the major consumers of aggregate at the global level. The extraction of virgin aggregates entails several environmental, sociological and economic impacts. Therefore, ...
Characterization of hot-mix asphalt made with recycled concrete aggregates that have been cured for 4 hours in the oven
(Trans Tech Publications, 2014)
[Abstract:] In this research a laboratory characterization of hot-mix asphalt (HMA) made with recycled concrete aggregates (RCA) from construction and demolition waste (CDW) as base layer in road construction has been ...
The influence of the mineral filler on the adhesion between aggregates and bitumen
(Elsevier, 2015)
[Abstract:] The loss of adhesion is a major mechanism of physical distress in hot-mix asphalt (HMA) because it could reduce the durability of HMA. In this study, active and passive adhesion between the aggregates and the ...
Adhesion of recycled concrete aggregates, demolition debris and asphalt
(Taylor & Francis, 2014)
[Abstract:] In this investigation, rolling bottle tests and boiling water tests were conducted to evaluate the effect of different fillers and treatments on the adhesion between recycled concrete aggregates (RCA) and ...
Laboratory evaluation of hot-mix asphalt containing construction and demolition waste
(Elsevier, 2013-06)
[Abstract], A laboratory study of the use of recycled concrete aggregates (RCAs) from construction and demolition waste (CDW) in hot-mix asphalt (HMA) for base courses in pavements was conducted. HMA mixes containing 0%, ...
Fatigue performance of bituminous mixtures made with recycled concrete aggregates and waste tire rubber
(Elsevier, 2017)
[Abstract:] Fatigue cracking is one of the main hot-mix asphalt (HMA) failure modes. The current laboratory investigation analyses the fatigue performance of HMA made with recycled concrete aggregates (RCA). An HMA type ...
Propuesta metodológica para el estudio global de las propiedades mecánicas de las mezclas bituminosas en frío
(Asociación Española de la Carretera, 2015)
[Resumen:] A pesar de haber sido empleadas durante décadas, el comportamiento mecánico de las mezclas bituminosas en frío no ha sido estudiado en la misma medida que el de las mezclas en caliente. Prueba de ello es la falta ...