Villalba Rama, DiegoParís, JoséCouceiro, IvánNavarrina, Fermín2025-07-102025-07-102025-01Villalba, D., París, J., Couceiro, I., & Navarrina, F. (2025). Multipatch IGA for stress-constrained minimum weight structural topology optimization. Engineering Optimization, 1–24. https://doi.org/10.1080/0305215X.2024.24369940305-215X1029-0273https://hdl.handle.net/2183/45489This is an Accepted Manuscript of an article published by Taylor & Francis in Engineering Optimization published online: 24 Jan 2025 , available at: https://doi.org/10.1080/0305215X.2024.2436994.[Abstract]: In this article, an isogeometric analysis (IGA) formulation with various patches (multipatch approach) is proposed to solve the structural topology optimization (STO) problem. The multipatch formulation enables the solution of STO problems with geometries not equivalent to rectangles by using IGA. For this purpose, a minimum weight with stress constraints (MWSC) problem is stated. A quadratic B-splines basis defined for each patch is used to model the material distribution. The structural analysis is computed with IGA. The introduction of all of the stress constraints in the formulation of the problem is made with an overweight constraint (OC). Finally, the multipatch approach is validated with the solution of some benchmark problems.engAttribution-NonCommercial 4.0 Internationalhttp://creativecommons.org/licenses/by-nc/4.0/Structural topology optimizationStress constraintsOverweight approachIsogeometric analysisMultipatch approachjournal articleopen access10.1080/0305215X.2024.2436994