Lage-Rivera, SilviaAres-Pernas, AnaDopico, SoniaCovas, JoséAbad, María-José2026-11-102026-11-102024-07-18Lage-Rivera S, Ares-Pernas A, Dopico-García MS, Covas J, Abad M-J. Comparing lignin and spent coffee grounds as bio-fillers in PLA 3D-printable filaments. Polym Compos. 2024;45(16):14566‐14579. doi:10.1002/pc.287821548-0569https://hdl.handle.net/2183/50198Financiado para publicación en acceso aberto: Universidade da Coruña/CISUG[Abstract] Material extrusion additive manufacturing is increasingly popular but requires new materials to expand its industrial applicability. This study compares the effects of two bio-fillers (lignin and spent coffee grounds (SCG)) in a biopolymer matrix, polylactic acid (PLA). The bio-fillers aim to enhance the sustainability of the resulting composites, tune their physical properties (rheology, thermal stability, mechanical resistance and water absorption) and improve 3D-printability by reducing the temperature at the nozzle. The composite with 15 wt.% SCG exhibited an elongation at break of 22.95% (vs. 8.42% for PLA), a printing temperature of 180_C (vs. 215_C for PLA) and a water absorption after 6 weeks immersion in water of 18.77 wt.% (vs. 5.04 wt.% of PLA), suggesting applications like hydroponic farming. Moreover, small amounts of SCG protected the composite against thermo-oxidative degradation during extrusion, while lignin enhanced the thermal stability of the composite.engAttribution-NonCommercial-NoDerivatives 4.0 Internationalhttp://creativecommons.org/licenses/by-nc-nd/4.0/3D printingBio-based materialsCoffee groundsExtrusion additive manufacturingLigninPLAComparing Lignin and Spent Coffee Grounds as Bio-fillers in PLA 3D-Printable Filamentsjournal articleopen access10.1002/pc.28782